Date Added: Monday 14 April, 2008
Luvvly jubbly! very, very nice set and looks really nice once fitted, i didn't encounter any difficulties upon fitting.
Gear knob: This is a simple matter of un-screw the old and srew on the new - job done!
Sleeve & Button: 1) Remove the old sleeve by twisting from one side to the other & pulling at the same time, it will come off (i didn't need to use a hairdryer as there was no glue on mine but i guess it would do the trick by heating it up for several minutes if necessary)
2) Slowly and steadily un-screw the button and retain the spring, simply screw the new button on.
3) Now fit the new sleeve, i managed to slide it on approximately half way before it became stuck, now here's a tip! hold the old sleeve over the end of the new one & tap it down with a rubber mallet, this enables you to knock the new sleeve on over the protruding button without causing any damage!
4) Then i gave the car a thorough 200 mile test drive round snowdonia!!!
Thanks to all at MX5Parts for a speedy (next day) delivery & the usual courteous service.
Hope this review helps all!
Rating: [5 of 5 Stars!]