Date Added: Saturday 19 July, 2003
As mentioned in the description these lights are very easy to fit, the most time consuming part is the removal of the original stop bar either by drilling the spot welds on the car or by cutting. Once fitted the light pattern is both nicely spread (unlike the original BSP Lo-Pro's) and very bright.
There was a little bit of vibration from the lamps after fitting them when they were up but fine adjustment of the stop appears to have cured this problem.
The only problem I have had from fitting this kit is re-alligning the headlight lids after installation, a few weeks on and i still have a large(ish) gap and the lid doesnt sit as low as it should at the front, no doubt, many hours of adjustment will cure this.
Message to Val: Did you have any problems with your light lids on the demo car? IF so any advice for lining them up properly?
Rating: [5 of 5 Stars!]