by Lawrence Mattinson
Date Added: Monday 20 October, 2014
Purchased this item to brighten up the rear end. I was disapointed with the quality and finish of the item. The stainless steel is quite thin and the edges are guillotine cut which leaves razor sharp edges both on the inside and outside edges, which I had to sand with fine wet & dry paper so as not to cut myself. The backing plate is universal with many holes, none of which match the Mazda hole centres so I had to drill through with new holes. Also this backing plate is 3mm too short to accept a UK plate so again I had to remove 1.5mm from each 'short' edge of my number plate. I then used the existing holes in the number plate to hold the whole assembly to the car. Once fitted it looks fine.
Rating: [3 of 5 Stars!]