Seat Side Bracket With LED Light, Mk1
If you have had the problem with the seat side pads, that they are just to soft, then we have the solution for you!
A specially designed seat side bracket that holds the seat in place, even in tight corners. We are certain that once you have driven with one of these fitted you'll get a completely new feel to your car and the way you drive it. The brackets can be installed on the left and right hand side of each seat and will fit both the drivers and passenger seat. There is also an integrated LED light, so the whole entrance is lighted when you open the doors.
Fits all Mk1 models only with intergrated head rest. These will not fit vehicles with seperate headrests.
Please Note: These are supplied individually so two are required per seat.
Once the seat has been removed from the car, decide which side you are fitting this to as it has a bearing on which side you have to mount the lamp. Screw the lamp into the bracket using the supplied screws and then insert the angled bracket into the slot in bottom of the moulded bracket. Next, remove the front screw of the seat rail and slide the angled bracket into place between the seat bottom and the seat rail. Once in place, replace and tighten the screw that was removed and refit the seat in the car.
The lamp is wired into the interior lights. If you remove the door sill trim, you will find the wires that come from the door switch. On most cars it will be a red & white wire, but it is best to check by removing the switch and tracing the wire. Connect the BLACK wire from the LED lamp to this wire and then run the other one towards the front of the car through the conduit and connect to any permenant live.
Only: £33.29 ex Vat
Total: £39.95 inc Vat
Please Note: Customers outside the EU will only pay the excluding VAT price. MX5 Parts have a clear pricing policy where we will always show the total price you pay. When comparing prices, please be aware that many other suppliers show their prices without VAT
Plenty In Stock