Date Added: Wednesday 04 April, 2007
I used a 13 mm drill intended for woodworking with a center point.
To prepare the rount hole for the bulholder I then used a square file
to file 6 mm wide and 3 mm deep growes positioned 90 degrees apart.
Then the rubbery soft bulb holder could be pressed into the slot. Piece
of cake - took me 20 minutes. Will now figure out the best method for
connecting the wiring, as no reveiw covered the finer point of this task.
It would greatly improve the appreciation of this product if wiring recommendations
could be supplied.
Rating: [4 of 5 Stars!]