by Andy Gardner
Date Added: Monday 22 February, 2021
Superb and done the job, but there are a few tips that are not clear in the instructions. 1. Take of the bolts by unclipping the wire retainers. 2. The short ones fit to the bonnet due to metalwork clearance. 3. If you don’t have taps then you need to drill a 6.1 mm not 4.8mm and then use the supplied nut. However to do this you need to un bolt the bonnet for access.
Finally when the four bolts are fitted don’t try and compress the struts, just lift the bonnet up higher and then struts should pop on.